MODEL H0592
7" ANGLE SANDER
INSTRUCTION SHEET
EYE INJURY HAZARD!
Always wear safety glasses
when using this tool to
prevent serious personal
INJURY HAZARD!
Always disconnect tool from
air to prevent unexpected
operation during service.
EXPLOSION HAZARD!
Never exceed 120 PSI.
Figure 1. Model H0592.
Introduction
Quick
Connector
Quick
Connector
Lubricator
Regulator
An excellent air sander that has a free speed of
4,500 RPM. Requires 90 PSI and consumes 12
CFM. Spindle thread nut is 5⁄8" x 11 UNC. Weighs
6.5 lbs. Pad size is 7". Air inlet is 1/4" NPT.
Your
Tool
Air
Compressor
Quick
Coupler
Quick
Coupler
Air Hose
Filter
Inventory
A. Air Sander .................................................. 1
B. Pin-Type Spanner Wrench......................... 1
C. Flat Wrench 19mm..................................... 1
D. 7” Sanding Pad .......................................... 1
E. Lock Nut ..................................................... 1
F. Handle........................................................ 1
Figure 2. Installing your tool.
Operation
Tool requires 90 PSI to operate correctly.
To improve tool lifespan, use a filter/lubricator/
regulator as shown in Figure 2. Otherwise, lubri-
cate daily with a couple drops of pneumatic tool oil
directly into the air fitting as shown in Figure 3.
Figure 3. Lubricating directly into air fitting.
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
COPYRIGHT © FEBRUARY, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#TR7971 PRINTED IN TAIWAN
|